536151

Voltcraft AT-200 Manual

29
Zoom out
Zoom in
Previous page
1/62
Next page
29
Carrying out Measurements
ƽ
In no event exceed the max. permitted input values within the over-
voltage category III. The frequency of the alternating volumes may
not exceed 400Hz! Do not contact circuits or parts of circuits if there
could be higher voltages than 25V ACrms or 35V DC pending within
them ! Danger! Before measuring, check the connected measuring
lines for damage such as, for example, cuts, cracks or squeezing.
Replace defective measuring lines immediately by new ones, defec-
tive measuring lines may not be used any longer! Danger!
a) Voltage measurement
Proceed as follows to measure AC/DC voltages:
- Connect the black measuring line with the COM socket
(7) and the red measuring line with the VΩ-socket (6) till
they are plane at the measuring instrument .
- Set the range selection switch (5) to position "V".
- Press the "MODE" button (9) additionally for measuring
AC voltages.
- Now connect the two measuring prods to the object to
be measured (battery, switching etc.).
- In the display (1), the polarity of the measuring value
concerned will be indicated together with the current
measuring value.
The voltage range "V" shows an input resistance of approx. 10MOhm. As soon as a
minus "-" appears for the direct voltage in front of the measuring value, the measu-
red voltage is negative (or the measuring prods have been mixed up).
Note: Due to the fact that the measuring input is very sensitive, it is possible that any
measuring values ("phantom measuring values") will be indicated if the measuring
wires are free (not connected to an object to be measured). This "phenomenon" is
normal and disappears as soon as you perform your measurement.
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft AT-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft AT-200 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info