650607

Toyotomi Omni 230 - type C Manual

10
Zoom out
Zoom in
Previous page
1/18
Next page
ADJUSTING THE FLAME
1. After lighting, wait for the heat chamber to reach operating temperature. This will take ten-fifteen minutes, after
which the flame will be visible through the mica window.
2. CHECK THE FLAME LENGTH
Look at the flame and check its length. Flame length is not necessarily even or uniform around the circumference
of the center disk. Some areas may be lower than others, but on maximum wick height, flame length should
average between 10 mm (3/8 in.) to 25 mm (1 in.).
lf necessary, raise or lower the wick by turning the wick adjuster knob within ADJUSTMENT RANGE to produce
the proper flame condition.
NOTE: DO NOT operate your heater with wick set TOO LOW or TOO HIGH. Doing so will decrease combustion
efficiency and increase production of unwanted emissions.
NOTE: ALWAYS observe the heater closely for the first 15-20 minutes after it is lighted to be sure it is properly
adjusted.
3. ADJUSTMENT OF WICK HEIGHT WITH WICK LIFE EXTENDER
Normal use of the wick and heat chamber over a period of time may make it impossible to achieve a
satisfactorily high flame level. Usually this occurs because the wick develops deposits on it that retard fuel flow
and evaporation. When this happens, the wick should be cleaned by “burning dry” as described in item 2, page
11 “INSPECTION OF THE WICK”.
When the “burning dry” cleaning procedure is no longer effective in restoring proper
flame height, adjust the wick life extender mechanism to the next higher position.
NOTE: DO NOT move the wick life extender to a higher position unless the wick
has been cleaned by “burning dry”.
To adjust the wick height rising the wick life extender, first release the automatic
extinguisher by pushing down on the MANUAL SHUTOFF.
Then pull the wick adjuster knob from its shaft by pulling outward.
BAD
TOO LOW
Produces odor and smoke
GOOD
CORRECT
Most efficient combustion
9
BAD
TOO HIGH
Produces smoke and soot
ADJUSTMENT RANGE
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 9
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi Omni 230 - type C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi Omni 230 - type C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info