650607

Toyotomi Omni 230 - type C Manual

11
Zoom out
Zoom in
Previous page
1/18
Next page
When the wick adjuster knob is removed, the wick life extender control can be seen
to contain 3 sequential holes marked 1 , 2 and 3. By pulling out and turning the
control dial counterclockwise, the stem pin of the adjuster can be moved from 1
to 2 and to 3 position as required. Each step upward from a lower to a higher
number increases the maximum wick adjustment range by 2 mm (approx. 1/13 in.).
After the wick life extender’s dial has been set, be sure the MANUAL SHUTOFF
knob is in the “OFF” position. Replace the wick adjuster knob, making sure it is
engaged securely on the wick adjuster shaft.
Repeat steps 1 through 3, as needed, in the section titled “ADJUSTING THE
FLAME”. When suitable flame length can no longer be achieved even on pin
position
3 , the wick should be replaced.
NOTE : DO NOT move adjuster to higher position until lower position no longer
gives adequate flame length, even after “burning dry”.
Before replacing wick, be sure to move the wick life extender dial back to its
1
position.
CHECK THE OPERATION OF THE AUTOMATIC EXTINGUISHER BEFORE
LIGHTING YOUR HEATER.
EXTINGUISHING THE FLAME
1. Turn the wick adjuster knob counterclockwise until it stops (about 3/4 turn). Within
a few moments, the flame will be completely extinguished and the heater will be off.
2. Make sure the flame is out completely.
3. DO NOT try to relight the heater for at least three (3) minutes after turning it off, as
this may cause smoke and odor.
MANUAL SHUTOFF
When quick shutoff is necessary, push the manual shutoff.
NOTE: For routine turn-off, DO NOT use the “Manual Shutoff” or activate the
“Automatic Extinguisher” by jarring the heater. These methods may cause
unwanted odor, soot and smoke. Only the wick adjuster knob should be used
for normal shutoff.
10
Wick heigh adjuster knob
(Wick life extender control)
Stem pin
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 10
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi Omni 230 - type C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi Omni 230 - type C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info