650607
9
Zoom out
Zoom in
Previous page
1/18
Next page
LIGHTING
NOTE: When you first use your new heater, ignite it out of the living area of your house, either in a garage or an
outside area protected from strong drafts. Burn it for about 15 minutes to remove all of the protective oil
present on the burner parts. lf this 15 minutes “burn-in” is done inside, some objectionable odor will be
observed. This procedure is necessary ONLY THE FIRST TIME you ignite your heater.
NOTE: lf you have fueled your heater for the first time, or if you are refueling it after it has been out of fuel for a
long time, you will need to wait about thirty (30) minutes for the wick to become fully saturated before
Iighting. Failure to allow enough time for the wick to become fully saturated may cause permanent damage
to the wick when it is lighted.
1. Turn the wick adjuster knob clockwise until it stops.
It makes a spark discharge sound in the process of lighting procedure, but turn the
wick adjuster knob clockwise until it stops.
As the wick rises within the heater, the wick adjuster knob turns with some
resistance and makes a sound like the winding of a clock. Once the wick has
reached its proper height, the automatic extinguisher is fully engaged.
The wick adjuster knob can now move freely left or right to adjust the flame.
2. LIGHTING WITH A MATCH
You should not have to light the heater with a match, but should it become
necessary, open the access door, lift the heat chamber up by holding the wire
handle and touch the match to the top of the wick. DO NOT allow burned parts of
the match to fall or remain on the wick.
NOTE: To restore the automatic igniter system to proper operation, replace worn-
out batteries, or if the igniter coil defective, replace it.
3. Be sure that heat chamber is properly seated by moving the wire heat chamber
handle left and right, and close the access door.
NOTE: An improperly seated heat chamber can cause high flame, smoke, and
potential damage to the heater itself. DO NOT leave the heater until you
have determined that the flame is burning normally, as described in the
following section.
8
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 8
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi Omni 230 - type C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi Omni 230 - type C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info