650607
12
Zoom out
Zoom in
Previous page
1/18
Next page
CARE AND MAINTENANCE
As with any good appliance, preventive as well as corrective maintenance is occasionally required. Please read the
following section carefully in order to enjoy the greatest benefits from your heater.
INSPECTlON OF THE WlCK
NOTE: One of the simplest but also the most important components of your heater is the wick.
With proper attention, the wick will last at least one heating season and, depending on the quality of the
fuel used, possibly longer, it helps to perform routine maintenance operations of the wick.
1. lndications that the wick may need attention are:
low flame
tar deposit on the top edge of the wick
difficulty in turning the wick adjuster knob
a flickering or dying flame
2. Clean the wick by burning dry as follows:
1) When the fuel gauge indicates empty, but the heater is still burning, raise the wick to its highest position and
allow the flame to consume the remaining fuel in the tank.
NOTE: Burning the wick dry can at times create odors. For the burning dry procedure, remove your heater from
the living area of your house into a well-ventilated area such as a garage or even a sheltered area
outside. If you burn the wick dry outside, be sure that the heater is not exposed to strong drafts during
the procedure.
2) After the heater has cooled completely, remove the heater cover as described in items 1 and 2 of the next
section.
3) Remove any residue from the wick with a small brush such as an old toothbrush. Cinders or soot in the burner
around the wick may be vacuumed away. Be careful when removing such material from the wick with a brush,
to do so gently so as not to tear the top surface of the wick.
4) Remove any tar deposits on the top of wick adjuster and primary air tube using a scraper.
NOTE: When good wick performance is no longer achieved by the burning dry process, it may be necessary to
replace the burned wick with a new one.
5) Before reassembling the heater, take a few minutes to wipe the parts with a soft cotton cloth or paper towels.
6) Reassemble the heater, following directions in item 11 of the next section.
NOTE: If the flame is still low after cleaning the wick, the wick may contain some water. It is then necessary to
replace the wick and empty all kerosene (paraffin) from the fuel tank. Dry the tank thoroughly and refill
with fresh, pure kerosene (paraffin).
11
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 11
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi Omni 230 - type C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi Omni 230 - type C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info