650607

Toyotomi Omni 230 - type C Manual

14
Zoom out
Zoom in
Previous page
1/18
Next page
3. Remove the four (4) wing nuts around the wick adjuster. Lift the wick adjuster off
the heater while moving it slightly back and forth.
4. Slide two fingers between the wick and the silver wick sleeve attached to the wick
adjuster. Lift the pins in the wick off the slots in the wick sleeve. After lifting all three
(3) pins off the slots, fold the wick and remove it. Replace the wick sleeve back into
the wick adjuster to protect the sleeve from damage.
NOTE: DO NOT damege the electrodes of Igniter unit on the
Wick Adjuster at the time of replacing the wick.
5. Place the wick adjuster on its side. Next, line up the three (3) openings in the wick
adjuster: 1) the holes in the sleeve, 2) the diagonal slots in the fixed part of the wick
adjuster, and 3) the slots in the moving part of the wick adjuster controlled by the
wick adjuster knob.
6. Fold the new wick in quarters and insert it into the wick adjuster from wick adjuster
bottom. Place one of the pins in one of the lined-up openings. lf you experience
difficulty, gently turn the wick adjuster knob clockwise. Then insert the two other
pins, turning the wick adjuster knob if necessary. DO NOT bend the sleeve.
7. Finally, gently press the wick, all along its circumference, against the wick adjuster
to insure that it is firmly in place.
8. Lower the wick adjuster into the fuel tank, guiding the tail of the wick so it fits over
the primary air tube and evenly into place.
Point the wick adjuster knob to the front of the heater. Insure that the wick adjuster
is centered over the studs on the fuel tank.
NOTE: The space between the wick adjuster and the primary air tube should be
even all around.
NOTE: Make certain the top of the wick adjuster and the top of primary air tube
are the same height. lf they are uneven, the flames tend to be uneven, too.
13
Electrodes of Igniter unit
WARNING: NEVER replace the sleeve upside down.
UP
Hole
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 13
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi Omni 230 - type C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi Omni 230 - type C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info