623977

Samson AirLine Synth Wireless System Manual

17
Zoom out
Zoom in
Previous page
1/24
Next page
12. Temporarily turn down the level of your mixer or amplifier and turn off the power
to your transmitter, leaving the AR300 receiver on. Then restore the previously
set level of your mixer or amplifier. With the transmitter off, the receiver output
should be totally silent; if it is, skip ahead to the next step. If it isn’t (that is,
if you hear some noise), you may need to adjust the AR300 Squelch control.
When the Squelch control is at its minimum setting, the AirLine Synth system
always provides maximum range without dropout; however, depending upon
the particular environment your system is used in, you may need to reduce that
range somewhat in order to eliminate band noise when the AX300 transmitter is
turned off. To do so, use the provided screwdriver to rotate the Squelch control
completely counterclockwise (to the “Min” position), then slowly turn it clockwise
until the noise disappears. If no noise is present at any position, leave it at its fully
counterclockwise “Min” position (so as to have the greatest overall range available).
13. When first setting up your AirLine Synth system in a new environment, it’s always
a good idea to do a walkaround in order to make sure that coverage is provided
for your entire performance area. Accordingly, turn down the level of your audio
system and turn on both the transmitter and receiver. Then restore the level of
your audio system and while speaking or singing at a normal performance level,
walk through the entire area that will need to be covered. As you do so, observe
the RF Meter on the AR300 receiver to make sure that it is close to reaching “75%”,
indicating that it is receiving sufficiently strong RF signal. Always try to minimize
the distance between transmitter and receiver as much as possible so that the
strongest possible signal is received from all planned transmission points. In
certain environments, it may be desirable to angle the AR300’s antennas differently
from the vertical position.
If you have followed all the steps above and are experiencing difficulties, contact your local
distributor or, if purchased in the United States, call Samson Technical Support (1-800-372-
6766) between 9 AM and 5 PM EST.
Setting Up Your AirLine Synth System
17
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson AirLine Synth Wireless System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson AirLine Synth Wireless System in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info