Manual Robland D630 (page 50 of 94) (English, German, Dutch, French)

625586

Zoom out

Zoom in

1/94

D 630 V1112 49

NederlandsFrançaisEnglishDeutsch

Calibration of the digital read out (Fig.6)

It is highly recommended that each time the planer knives are changed, the digital

read out is calibrated, this to avoid measurement errors.

Calibration is done as follows:

- set the thicknesser table at a random height and thickness a sample.

- now measure exactly the thickness of the sample.

- now the digital read out has to be set at the same measure, and this can be achieved as follows:

press simultaneously the buttons F and SET on the read-out:

Now the read-out begins to count up at 3 progressive speed rates:

- Rate 1: at 1Hz for 10 sec.

- Rate 2: at 10 Hz for 10 sec.

- Rate 3: at 1000 Hz for as long as the 2 buttons F and SET are held.

- Shortly before the desired value is reached, release the two buttons and press the same two buttons

so as to approach the desired value with the slowest rateof 1 Hz.

The thicknessser now is calibrated over the full 300 mm capacity.

To set the read-out at 0, simultaneously press Set and RESET.

IMPORTANT

Before starting to work on the thicknesser always ensure that the anti-kickback protection ngers are

clean and hang down freely in position under their own weight. These anti-kickback ngers should be

inspected on a regular base, and kept clean and free of any resin deposits whatsoever. Ensure the

correct position and locking of the dust chute. Roller supports should be used when long workpieces

are machined. Ensure the ticknesser table is well cleaned, since a smooth table surface is essential

for good operation of the thicknesser.

Fig.6

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland D630 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland D630 Manual

Product: