819505

Parkside PMRA 20-Li B2 - IAN 462730 Robot Manual

54
Zoom out
Zoom in
Previous page
1/388
Next page
GB MT
54
1. Place the mower on the target area of
the lawn.
2. If necessary, open the cover (1).
3. Unlock the display (10) with the 4-digit
PIN.
4. Press the OK button (7) to enter the
main menu.
5. Select “Spot mode” with the arrow but-
tons (6).
The display shows “Close the cover to
start”.
6. Close the cover (1) and the mower
starts mowing with the xed point.
The lawn mower mows in an anti-
clockwise spiral direction and
switches to “Automatic mowing” after a
mowing radius of 1 m or 3.5 minutes of
mowing.
If the mower encounters an obstacle, the
mower stops, the display indicates that
mowing has stopped and the mower
switches to standby mode.
When the lawn mower hits the boundary
wire (11), it continues mowing in the oppo-
site spiral direction.
If the mower is outside the bounda-
ry wire (11) or on the charging sta-
tion and you select “Spot mode”, the dis-
play shows “Please place inside the
boundary and try again”. Set the mower
down inside the boundary wire (11) and
next to the charging station and restart
“Spot mode”.
If the battery charge level is less
than 30 %, the display shows “Low
battery voltage” after 2 seconds. Charge
the lawn mower before you can start mow-
ing with the xed point.
Setting the rain sensor
Never operate the lawn
mower during storms and
make sure to disconnect the charg-
ing station from the mains.
If the rain sensor is switched on, the lawn
mower returns to the charging station when
it rains. The rain sensor is always activated
in the delivery state.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select “Set-
tings”.
5. Conrm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
“Rain mode”.
7. Conrm the selection with the OK but-
ton (7).
8. To deactivate the rain sensor, select
“Deactivate” and conrm the selection
with the OK button (7).
To activate the rain sensor, select “Acti-
vate” and conrm the selection with the
OK button (7).
Select a time in minutes when
the lawn mower should start op-
erating again after the rain.
Decide also whether the lawn mower
should make up for the break in operat-
ing time caused by the rain.
Conrm each selection with the OK
button (7).
9. Return to the main menu with the back
button (5).
We advise against having the lawn
mower operate while it is raining.
… 54 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PMRA 20-Li B2 - IAN 462730 Robot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PMRA 20-Li B2 - IAN 462730 Robot in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 4.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info