713038

Omnitronic BOB series Manual

29
Zoom out
Zoom in
Previous page
1/36
Next page
29
•
EN
Notes
To avoid interfering noise, switch off the subwoofer or set the output controls to minimum prior to connecting
and disconnecting equipment. A good cable run improves the sound quality remarkably. Signal cables
should be short and direct, since high frequencies will mostly be absorbed if cables are unnecessarily long.
Besides that a longer cable may lead to humming and noise trouble. If long cable runs are unavoidable, you
should use balanced cables. In order to obtain highest sound quality, only use high-quality cables.
BOB-4 satellite speakers
1) Connect the passive satellite speakers to the BOB-10A subwoofer’s speaker outputs (TO SATELLITE
LEFT/RIGHT) using the included connection cables. Up to four satellites per subwoofer output can be
operated in parallel at 4 ohms.
For locking the connection turn the plug to the right. For unlocking pull the unlock button and turn the
plug to the left and pull it out of the socket.
2) Via the rear screw terminals, the speaker signal is simply looped through to the next satellite.
To facilitate handling, the terminals can be removed from their plug-in connections and replaced after
connection. Make sure that all speakers have the same polarity
.
We recommend using speaker cables with
a conductor cross-section of at least 2.5 mm². Suitable cables are included in the accessory kit together
with the U-brackets.
active
TOP
TOP
TOP
TOP
TOP
TOP
TOP
TOP
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Omnitronic BOB series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Omnitronic BOB series in the language / languages: English, German as an attachment in your email.

The manual is 10,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info