713038
30
Zoom out
Zoom in
Previous page
1/36
Next page
30
EN
Connecting a home cinema system
Connect the active BOB-10A subwoofer to a passive signal output of the AV receiver and the BOB-4 satellite
speakers to the amplified outputs of the AV receiver.
BOB-82X subwoofer
1) Connect the positive pole of the speaker cable coming from the amplifier to the red terminal clamp (LEFT
INPUT) and the negative pole of the speaker cable coming from the amplifier to the black terminal clamp
(LEFT INPUT) of the subwoofer. Connect the second amplifier channel to the right clamps of the
subwoofer in the same manner.
2) Connect the passive BOB-4 satellite speakers to the upper clamps SAT OUT (red clamp = positive pole,
black clamp = negative pole). Up to two satellites per subwoofer output can be operated in parallel at 4
ohms. Via the rear screw terminals of the BOB-4 satellites, the speaker signal is simply looped through to
the next satellite. We recommend using speaker cables with a conductor cross-section of at least 2.5 mm².
active
REAR L
FRONT L
REAR R
FRONT R
CLAMPS
IN L IN R
CLAMPS
AMP
CLAMPS
OUT L
CLAMPS
OUT R
PASSIVE
SAT OUT
LEFT
RIGHT
SAT OUT
INPUT
LEFT
RIGHT
INPUT
REAR L
FRONT L
REAR R
FRONT R
SUB
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Omnitronic BOB series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Omnitronic BOB series in the language / languages: English, German as an attachment in your email.

The manual is 10,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info