Manual Metabo HDM 1000 (page 26 of 56) (English, German, Dutch, French)

451429

Zoom out

Zoom in

1/56

Set the drive belt to the lowest spindle speed and start

the machine. With the long hole drill bit, supplied with the

hollow footstock centre, chucked in an electric drill the

hole is drilled into the workpiece. Remove drill bit at

regular intervals to help clear the bore chips from the

hole.

Note: both the lathe and the drill must be running. With

either one not running, the drill bit will not centre and can,

depending on the length of the workpiece

run out.

The drill bit must turn clockwise.

Long, small diameter workpieces must be supported to prevent vibration. The workpiece must either be already

completely turned round, or a short section must be turned round to accommodate the steadying rest’s rollers. After

installing the workpiece between centres each support roller is individually set against it, applying only very light

pressure.

15 Steadying Rest

Install template in template extrusion.The template extrusion is mounted with two toolrests to

the machine bed. Set height so that the copying chisel’s

cutter edge is on the centre line.

16 Copying Attachment

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metabo HDM 1000 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metabo HDM 1000 Manual

Product: