451429
24
Zoom out
Zoom in
Previous page
1/56
Next page
12 3-/4-Jaw Chuck
Important!
The maximum workpiece diameter or cross section must not be exceeded. It opened too wide, the jaws are not securely
held by the internal gear, and can be ejected from the chuck body by centrifugal force, causing severe personal injury.
12.1 Mounting
The workpiece must rest fully against the body of the
chuck, so the chucks can grip the workpiece with their full
width.
12.2 Maximum Workpiece Diameter
The max. workpiece diameter for the 3-jaw chuck is
67 mm. With reversed chucks (see section 12.3) the
max. diameter is 125 mm.
The max. workpiece cross section for the 4-jaw chuck is
67 x 67 mm, with reversed chucks 125 x 125 mm.
24
After reversing check for proper operation. When installed correctly all jaws meet evenly in the centre.
4-jaw chuck 1. jaw #4 into groove #1
2. jaw #3 into groove #2
3. jaw #2 into groove #3
4. jaw #1 into groove #4
3-jaw chuck 1. jaw #3 into groove #1
2. jaw #2 into groove #2
3. jaw #1 into groove #3
12.3 Reversing the Jaws.
Screw the jaw chuck onto the spindle. Its locating pin
must sit in the hole of the reatining ring. Tighten the
clamping screw in the retaining ring.
If required, a workpiece can be mounted in a 3- or 4-jaw
chuck.
To install the chuck, first a retaining ring is mounted on
the headstock spindle.
To increase the chucking capacity the jaws can be reversed. It is important to install the reversed jaws in the correct
order, otherwise they will not be centered in the chuck. ‘Reinstall in the following sequence:
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo HDM 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo HDM 1000 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info