451429
25
Zoom out
Zoom in
Previous page
1/56
Next page
13 Boring Tool
Drill a hole of at least ¥ 20 mm into the workpiece, use a
drill chuck in the tailstock centre sleeve.
For hollowing out with the boring tool the workpiece is
chucked in a collet chuck or 3-/4-jaw chuck.
The revolving centre is replaced by the hollow footstock
centre. Apply a few drops of oil or carnaube wax to the
locating hole to keep the timber from scoring. Install the
workpiece between centres.
Drill locating hole as per section 9.0 of this manual, and
widen with a 60˚ countersink to fit the hollow footstock
centre.
14 Long Hole Boring with the Hollow Footstock Centre
25
The finished workpiece is cut from the chuck with the
parting tool. For safety reasons the parting cut must be
made at least 3 times as wide the tools’ thickness.
Replace drill chuck with boring tool, position cutter plate
of boring tool so that it cuts with 1/2 width of the cutting
edge.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo HDM 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo HDM 1000 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info