629293

Guardall WINDSOR SERIES 300i Manual

20
Zoom out
Zoom in
Previous page
1/48
Next page
20 — Installation & Programming Guide
Keypad Zones
Any zone can be programmed to operate on a keypad. Firstly, the zone must be
connected to the zone and tamper inputs in the keypad (see keypad section for wiring
instructions). Once the zone is connected to the Keypad it must be programmed. Each
keypad zone can be identified using programming codes 051 - 056. The zone number
must be entered to identify the zone to the keypad i.e. if zone 15 is connected to Keypad
3 then program as follows :-
From engineer mode enter 053 for Keypad 3 then enter a two digit number equivalent to
the zone number e.g. 15 for Zone 15.
051 Keypad 1 2 digit zone number
052 Keypad 2 2 digit zone number
053 Keypad 3 2 digit zone number
054 Keypad 4 2 digit zone number
055 Keypad 5 2 digit zone number
056 Keypad 6 2 digit zone number
The zone number to be entered cannot be more than the maximum zones connected to
the panel. If 13 zones are connected, then zone numbers between 1 and 13 can be
used. The zone on the panel or expanders that is now connected to the Keypad will only
operate from the keypad. i.e. if Zone 13 is on the keypad, then Zone 13 on the panel/
expander will not be processed.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Guardall WINDSOR SERIES 300i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Guardall WINDSOR SERIES 300i in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info