583758

Garmin GPSMAP 2110 Manual

15
Zoom out
Zoom in
Previous page
1/106
Next page
GPSMAP 2106/2110 Owner’s Manual 7
GETTING STARTED > USING SIMULATOR MODE
Using Simulator Mode
Simulator Mode is great for practicing with the unit if you are indoors and
satellite signals are not available. When the GPSMAP 2106/2110 is in Simulator
Mode, the GPS receiver is turned off. You cannot use the unit for actual
navigation.
NOTE: Do not try to navigate in Simulator Mode. While in Simulator Mode,
the GPS receiver is turned off. Any satellite signal strength indicators shown
are only simulations and do not indicate the strength of actual satellite signals.
To turn on Simulator Mode:
1. Press and hold ADJ/MENU to open the Main Menu.
2. Press up or down on the ROCKER to highlight the System tab.
3. Press right on the ROCKER to highlight the General sub tab.
4. Highlight the System Mode field, and press ENTER.
5. Highlight Simulator, and press ENTER.
When Simulator Mode is active, the message “Simulating Operation” appears in
the status bar at the top of each page.
To
set up Simulator Mode:
Highlight the Setup button, and press ENTER. The Simulator Setup
window appears. The following options are available:
• Current Time/Current Date—enter a simulated date and time.
• Speed—enter a simulated speed.
• Track Control—select track control. Auto Track steers to the current
navigation point; User Track allows you to enter a heading in the
Track field.
• Track—enter a simulated heading.
• Set Position—set your location while in Simulator Mode.
Use the Set Position soft key to set your location while in Simulator Mode.
You can also control the speed and track from the Compass or Highway Page.
Press up or down on the ROCKER to increase or decrease the speed; press left or
right to change the heading.
To
turn off Simulator Mode:
1. Press and hold ADJ/MENU to open the Main Menu.
2. Press up or down on the ROCKER to highlight the System tab.
3. Press right on the ROCKER to highlight the General sub tab.
4. Highlight the System Mode field, and press ENTER.
5. Highlight Normal, and press ENTER.
When Normal Mode is active, the message “Normal” appears in the status bar at
the top of each page.
… 15 …


Need help? Post your question in this forum.

Forumrules
1

Forum

garmin-gpsmap-2110

Reset search

  • I have acquired a Garmin 2110 with a GPS17.
    The cable between the two has been carefully cut - I assume to remove it from the previous vessel. I have connected all the cables together as per the Basic Installation shown in the handbook. All works fine.
    My question is how can i reconnect the two (front and rear) looms together. The wires from the GPS17 are too fine to solder and not of sufficient size as to allow connection by electrical Mobloc.
    Can anyone help me by telling me what they have used to connect these looms together?
    Thanks in anticipation
    Ian Hutchinson Submitted on 15-4-2021 at 11:46

    Reply Report abuse

  • I have just acquired a Garmin 2110 and GPS17.
    The wires that connect the two together have been carefully cut - I assume to enable the units to be removed from the previous vessel. I have connected all the wiring together as per the Basic Wiring diagram and all worked perfectly.
    However the wires from the GPS17 are extreamly delicate and will not (maybe my inexperience ) allow solder connections in order to make the installation complete. My question is what can I use to make a permanent fixing of the two (front and rear) looms?
    I have tried using a small mobloc but the wires in the GPS17 loom are too fine to make a good connection.
    Any help would be greatly appreciated
    Ian Hutchinson Submitted on 15-4-2021 at 11:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPSMAP 2110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPSMAP 2110 in the language / languages: English as an attachment in your email.

The manual is 6,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info