I have just acquired a Garmin 2110 and GPS17.
The wires that connect the two together have been carefully cut - I assume to enable the units to be removed from the previous vessel. I have connected all the wiring together as per the Basic Wiring diagram and all worked perfectly.
However the wires from the GPS17 are extreamly delicate and will not (maybe my inexperience ) allow solder connections in order to make the installation complete. My question is what can I use to make a permanent fixing of the two (front and rear) looms?
I have tried using a small mobloc but the wires in the GPS17 loom are too fine to make a good connection.
Any help would be greatly appreciated
Ian Hutchinson

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

• First, read the manual;
• Check if your question has been asked previously;
• Try to ask your question as clearly as possible;
• Did you already try to solve the problem? Please mention this;
• Is your problem solved by a visitor then let him/her know in this forum;
• To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
• Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Post your question in this forum.

Info