583758

Garmin GPSMAP 2110 Manual

14
Zoom out
Zoom in
Previous page
1/106
Next page
6 GPSMAP 2106/2110 Owner’s Manual
GETTING STARTED > INITIALIZING THE GPS RECEIVER
Receiver Status and Accuracy
The Status field on the Info sub tab shows the receiver status. Current accuracy
is shown in the EPE (Estimated Position Error) field. Accuracy uses the number
of received GPS satellites, signal strength, and satellite orientation, to calculate
location accuracy in feet or meters. The Status field shows one of the following
conditions:
• Searching for Satellites—the receiver is looking for any satellites and
collecting data from satellites visible at its last known or initialized
location, but has not collected enough data to calculate a fix. This process
can take up to five minutes.
• Ready For Navigation—at least three satellites with good geometry
were acquired, and your location is now being calculated in latitude
and longitude; or at least four satellites were acquired and your location
is being calculated in latitude, longitude, and elevation. “Ready For
Navigation with WAAS” appears when you are receiving WAAS satellite
corrections in 2D or 3D, and a D appears on the strength bar of satellites
being corrected.
After the receiver has collected information from at least three satellites, the
Status field shows either “Ready for Navigation” or “Ready for Navigation with
WAAS.” The GPSMAP 2106/2110 is now ready for use. Press QUIT to return to
the Map Page.
GPS Setup
The Setup sub tab provides access to functions and features relating to initializing
the GPS receiver.
To access the GPS Setup sub tab:
1. Press and hold ADJ/MENU to open the Main Menu.
2. Highlight the GPS tab, and then highlight the Setup sub tab.
Setup Sub Tab
The Setup sub tab contains the following options:
Skyview Orientation—allows you to select a sky view orientation, either North
Up or Track Up, for the GPS Info sub tab only.
Source
—set to Garmin when using a Garmin sensor (GPS 17); set to NMEA
when using any other GPS NMEA source.
WAAS—turns WAAS on or off.
The following soft keys are active only when the unit is not receiving satellites
and the Source is not set to Garmin:
• AutoLocate—allows the receiver to find your location automatically. This
process can take up to five minutes.
• Set Position—allows you to initialize the receiver from the Map Page to
initially help the receiver acquire satellites more quickly.
… 14 …


Need help? Post your question in this forum.

Forumrules
1

Forum

garmin-gpsmap-2110

Reset search

  • I have acquired a Garmin 2110 with a GPS17.
    The cable between the two has been carefully cut - I assume to remove it from the previous vessel. I have connected all the cables together as per the Basic Installation shown in the handbook. All works fine.
    My question is how can i reconnect the two (front and rear) looms together. The wires from the GPS17 are too fine to solder and not of sufficient size as to allow connection by electrical Mobloc.
    Can anyone help me by telling me what they have used to connect these looms together?
    Thanks in anticipation
    Ian Hutchinson Submitted on 15-4-2021 at 11:46

    Reply Report abuse

  • I have just acquired a Garmin 2110 and GPS17.
    The wires that connect the two together have been carefully cut - I assume to enable the units to be removed from the previous vessel. I have connected all the wiring together as per the Basic Wiring diagram and all worked perfectly.
    However the wires from the GPS17 are extreamly delicate and will not (maybe my inexperience ) allow solder connections in order to make the installation complete. My question is what can I use to make a permanent fixing of the two (front and rear) looms?
    I have tried using a small mobloc but the wires in the GPS17 loom are too fine to make a good connection.
    Any help would be greatly appreciated
    Ian Hutchinson Submitted on 15-4-2021 at 11:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPSMAP 2110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPSMAP 2110 in the language / languages: English as an attachment in your email.

The manual is 6,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info