535711
17
Zoom out
Zoom in
Previous page
1/78
Next page
17
The function keys I/II/III are home automation
keys used to operate Programmes setup in the
PC setup software
INSTALLING THE CONTROL PANEL
1. Pull the clip outwards together with pushing
the mounting bracket downwards to detach
it from the rear of the Control Panel.
2. Use the mounting bracket as a template to
mark the position of three fixing holes on the
wall. Drill the holes using a 5mm drill bit.
To complete installing the Control Panel on the
wall as described in the next steps, the Siren’s
battery charging must be complete since the
same 12V power supply adaptor is used to
power up the Control Panel. When charged,
remove the power adaptor and refit the Siren’s
rear battery cover again.
3. Remove the battery cover from the rear of
the Control Panel.
4. Ensure that the Reset jumper link (P1) and
External Tamper Switch Jumper (P51) are
set in the OFF position
The use of ear defenders are advisable for the
next step just in case the tamper alarm sounds
continuously.
If the tamper alarm of the Control Panel sounds
continuously, reset the alarm by pressing the
following keys on the Control Panel:
The factory default user access PIN code is
1234’.
DC Jack
Terminal
Block
Battery
Connector
P51: External
Tamper
P1: Reset
User access PIN code
P51 Jumper Link
P1 Jumper Link
OFF
ON
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland HISK1 GlobalGuard Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland HISK1 GlobalGuard Alarm System in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info