535711

Friedland HISK1 GlobalGuard Alarm System Manual

15
Zoom out
Zoom in
Previous page
1/78
Next page
15
Under the cover you will also find a row of 5 DIP
Switches labeled SW3 and a “LEARN” button.
1. Ensure that DIP Switch5 of SW3 on the LED
indicator board is set to OFF (“SIREN”) for
use with this alarm system.
2. DIPswitch1 marked “ALARM TIME” is used to
limit the maximum period for which the
external siren will sound before it will be
automatically shut down, (even if the Control
Panel is still in alarm):
ON 3 minutes
OFF 10 minutes
3. DIPswitch2 marked “AJ“ does not function for
this system and should be ignored.
4. DIPswitch3 marked ALARM SOUND if OFF
will prevent the siren from sounding during an
alarm, (this will not affect the warning beeps):
ON Siren enabled
OFF Siren disabled
5. The Solar Siren will acknowledge signals
from the Remote Control, Keypad and Control
Panel by beeping and flashing the LEDs. It is
possible to disable these acknowledgement
beeps DIPSwitch4 marked “BEEP SOUND”.
ON beeps enabled
OFF beeps disabled
CHARGING THE SOLAR SIREN
BATTERY
Before getting your system up and running, it is
important to initially charge up the battery for the
Solar Siren for approximately 4 hours.
1. Remove the rear battery cover as shown
below.
2. Connect the 6V NiMH battery pack inside as
shown below.
3. Connect the Control Panel’s 12V Power
supply adaptor to the DC charging jack
shown above and plug the adaptor into the
mains to charge the battery.
4. Charge the battery for approximately 4
hours. In the meantime you can install the
PIR movement detector, door/ window
contact detector and Control Panel in
position.
5. After charging is complete, remove the
Control Panel’s adaptor and refit the siren’s
battery cover in place.
Note: The Control Panel cannot be fully installed
until the Siren has completed charging.
ON
1 2 3 4 5
Battery connector
DC charging jack
6V NiMH
Battery
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland HISK1 GlobalGuard Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland HISK1 GlobalGuard Alarm System in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info