535711

Friedland HISK1 GlobalGuard Alarm System Manual

14
Zoom out
Zoom in
Previous page
1/78
Next page
14
EXTERNAL SOLAR SIREN
The Siren is encapsulated within a tough
polycarbonate housing that also provides full
protection against adverse weather conditions.
An LED indicator unit is built into the Siren to act
as a visible deterrent and indication that the
system is active. The LEDs will slowly and
alternately flash whether the system is Armed or
Disarmed. When an alarm occurs the LEDs will
flash rapidly together.
An integral tamper switch provides additional
security protection to the Siren and will
immediately trigger an alarm should any
unauthorized attempt be made to interfere with
and remove the Siren cover.
The Siren is powered by a rechargeable nickel-
metal hydride (NIMH) battery. A solar panel
mounted on the top of the housing charges the
battery during daylight hours. During darkness,
only a small amount of energy is required to
operate the Siren unit.
POSITIONING THE SOLAR SIREN
The recommended mounting height for the Siren
is at first floor window height of your property on
the external wall so that it can be easily seen
and heard. The Siren should be mounted on a
sound flat surface so that the rear tamper switch
is not activated when mounted.
Ensure that the tamper switch does not fall
into the recess between brick courses as this
could prevent the switch from closing and
give a permanent tamper signal.
In order to provide the maximum amount of
daylight to the solar panel, the Siren should
ideally be mounted on a south facing wall.
However, an easterly or westerly position will
suffice. Mounting the device on a north facing
wall should be avoided as this could mean that
during the short dark days of winter months the
solar panel may not receive sufficient daylight in
order to maintain the battery charge at
acceptable levels.
Shadows cast by neighboring walls, trees and
roof overhangs should also be avoided. If the
Siren is to be mounted below the eaves, it
should be positioned a distance of at least twice
the width of the eaves overhang below the
eaves. Remember that in winter the sun is
lower in the sky and you should avoid winter
shadows where possible.
The Solar Siren contains a sophisticated radio
receiver. However, reception of radio signals
can be affected by the presence of metallic
objects within the vicinity of the Siren. It is
therefore important to mount the Siren a
minimum distance of 1 metre away from any
external or internal metalwork, (i.e. drainpipes,
gutters, radiators, mirrors etc). Be especially
aware of radiators mounted on the inside wall
behind possible locations for the Siren.
Ensure that the position selected for the Siren is
within effective range of the Control Panel.
CONFIGURING THE SOLAR
SIREN
The Siren has already been pre-linked to the
Control Panel from the factory. It has also
been preconfigured to operate with your
system.
However should you wish to change the DIP
switch settings in the battery compartment,
please read as follows:
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland HISK1 GlobalGuard Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland HISK1 GlobalGuard Alarm System in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info