535711

Friedland HISK1 GlobalGuard Alarm System Manual

16
Zoom out
Zoom in
Previous page
1/78
Next page
16
CONTROL PANEL
Note that to fully install the Control Panel in
position, the siren’s battery charging
process must be complete. If it has not yet
completed then you should prepare
mounting the Control Panel’s mounting
bracket in position as described below.
POSITIONING THE CONTROL PANEL
When choosing a suitable location for the
Control Panel, the following points should be
considered.
1. The Control Panel should be located in a
position out of sight of potential intruders
and in a safe location, but easily accessible
for system operation and leaving and
entering the house within the set time
period.
2. The Control Panel should be mounted on a
sound flat surface to ensure that the rear
tamper switch on the Control Panel is
closed when the Panel is mounted. The
Control Panel should be mounted at a
convenient height of between 1.5 and 2
metres and in a position where it will be
seen each day.
Note: If small children are in the household,
further consideration should be given to
keeping the unit out of their reach.
3. It is recommended that the Control Panel
should be positioned such that the
Exit/Entry tone (emitted by the Control
Panel) can be heard from outside the
property.
4. The Control Panel should be mounted
within a protected area so that any intruder
cannot reach the Control Panel without
opening a protected door or passing
through an area protected by a PIR
Detector when the system is armed.
5. The Control Panel must be located
within reach of a mains socket.
6. DO NOT fix the Control Panel onto or
very close to metalwork (i.e. radiators,
water pipes, etc) as this could affect the
radio range of the device.
CONTROL PANEL OVERVIEW
The LEDs indicate the following status:
On Steadily Flash Off
AC power in
use
Battery in use /
Flash slowly:
Low battery
-----
System is
Fully/holiday
armed
System is set
in Part-Arm-I/II
System
disarmed
System
message
Alarm memory Normal
Panic button
is pressed
----- Normal
Panic Button
LCD Display
LED Indicators
Function/Programme
activation keys
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland HISK1 GlobalGuard Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland HISK1 GlobalGuard Alarm System in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info