624064
17
Zoom out
Zoom in
Previous page
1/22
Next page
13
Maintenance
Maintenance
Warning
Disconnect the test set’s alligator clips from
any metallic connections before performing
any maintenance. Read all instructions
completely and understand possible hazards
to end user if repairs are not performed
properly.
Batteries are hazardous to handle. Do not
allow the terminals to be shorted together.
Severe burns or explosion can result if not
handled properly. Dispose of the battery
properly to ensure contacts cannot short.
Disposal may be restricted by local laws.
Cleaning
For general cleaning, wipe the case, front panel keys,
and lens using a soft cloth slightly dampened with
water or a non-abrasive mild cleaning solution that
does not harm plastics.
Caution
Do not use CRC Cable Clean
®
or any
chlorinated solvent or aromatic
hydrocarbons on the test set. Doing so will
damage the test set.
If the Test Set Stops Operating
If the test set stops operating, remove the 9 V battery
as described in the next section, wait at least 40
seconds, then replace the battery. This resets the test
set. Use the same battery if you know it is good or use a
new battery if you are not sure. If it still does not
operate, contact Fluke Networks Technical Support.
If the Test Set Gets Wet
If moisture gets inside the test set, let the test set dry at
normal room temperature for 24 hours.
Replacing the Battery
Replace the battery when the BATTERY LED flashes red.
See Figure 2.
Warning
To prevent unreliable test results, replace
the battery as soon as the BATTERY LED
flashes.
Before you remove the battery door,
disconnect the test leads from the line.
Use only a 9 V battery, correctly installed, to
supply power to the test set.
Do not use the test set without the battery
door installed.
Use caution when handling batteries. Do
not let the terminals short together. Dispose
of batteries properly to ensure terminals
cannot short. Disposal may be restricted by
local laws.
Caution
Do not over tighten the screws. The battery
door screws should be torqued to a
maximum of 0.904 N-m or 8 in-lb.
Note
The screws do not come out of the battery
door.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks TS23 PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks TS23 PRO in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info