624064
18
Zoom out
Zoom in
Previous page
1/22
Next page
14
TS23 PRO Test Set
Users Guide
GOL07.EPS
Figure 2. How to Replace the Battery
Replacing the Belt Clip
You can replace the belt clip if it is damaged. To order a
replacement belt clip, contact your local Fluke
Networks authorized distributor.
To replace the belt clip:
Refer to Figure 3.
1
Use a Phillips screwdriver to remove the two
screws that attach the belt clip to the test set.
Remove the belt clip.
2
Put the screws into the plate on the new belt clip.
3
Put the end of the plate into the slot as shown in
Figure 3 before you align the screws with the holes
in the test set.
4
Tighten the screws.
Caution
Do not over-tighten the screws for the belt
clip. If you do, you can cause damage to the
screw holes.
GOL06.EPS
Figure 3. How to Remove and Install the Belt Clip
Replacing the Belt Clip Protector
The belt clip protector prevents damage to the belt clip
if you drop the test set. You can replace the protector if
it is damaged:
1
Remove the belt clip as described in the previous
section.
2
Remove and install the protector as shown in
Figure 4.
GOL09.EPS
Figure 4. How to Remove and Install
the Belt Clip Protector
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks TS23 PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks TS23 PRO in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info