779800
34
Zoom out
Zoom in
Previous page
1/42
Next page
Kapitelüberschrift
32
Cutting particle boards
-To prevent raw edges when cutting particle boards, do not set the saw blade higher than 5
mm above the workpiece thickness.
When you are finished cutting
1. First turn the table saw off and then the dust extractor. The saw blade will
continue to rotate for some time.
2. Remove the cutting waste from the saw blade when the saw blade returns to the rest-
ing position.
3. Disconnect the table saw from the power supply by pulling the mains plug out of the
socket.
4. Let the table saw cool off completely.
Releasing the overload protection
This table saw is equipped with overload protection. If the motor has overloaded, the overload
switch automatically deactivates it to protect the table saw from overheating.
1. If the overload protection has been activated, switch the table saw off.
2. Wait until the engine has cooled down.
3. Press the overload switch (9) and switch the table saw on.
Removing jammed material
m WARNING! Risk of injury!
Incorrect handling of the table saw poses a risk of serious injury.
-Immediately switch the table saw off and pull the mains plug out of the socket if the saw
blade catches in the workpiece or any other blockages occur.
-Use protective gloves. Do not touch the saw blade with your bare hands.
Changing the saw blade (Fig. 9/15)
m WARNING! Risk of injury!
Incorrect handling of the table saw poses a risk of serious injury.
-Ensure that the table saw is not connected to the mains supply.
-Use protective gloves. Do not touch the saw blade with your bare hands.
1. Turn the saw blade to the maximum position out of the saw table.
2. Remove the saw blade guard (4) from the riving knife (34).
3. Remove the table insert (A) with a screwdriver (not included).
4. Make sure that the angle adjustment of the saw blade is set to 0°.
5. Place the saw blade spanner (25) on the saw blade flange (I) and one spanner (25) at
the fixing nut (J).
Operation
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DX254TS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info