Manual Ferrex DX254TS (page 33 of 42) (English)

779800

Zoom out

Zoom in

1/42

Operation

Performing cross cuts

m WARNING! Risk of injury!

Improperly handling the table saw poses a risk of serious injury.

-Always take hold of the guided workpiece and never of the unguided work piece that is being

cut off.

-Always push the cross guide forward until the workpiece has been cut through completely.

1. Set the transverse stop (2) as necessary. If the saw blade is also to be set at an angle,

push the transverse stop into the right-hand side groove to prevent your hand and the

transverse stop from coming into contact with the

saw blade guard.

2. Lower the saw blade guard onto the saw table. The

saw blade guard is pushed up by the workpiece

while sawing.

3. Firmly push the workpiece against the transverse

stop.

4. Switch on the dust extractor ﬁrst and then the

table saw.

5. To perform a cut, push the cross guide and the workpiece in the direction of the saw

blade.

Cutting narrow workpieces

Be absolutely sure to use the push stick (15) when performing lengthwise cuts for workpiec-

es with a width of under 150 mm. For shorter workpieces, the push stick must be used at the

beginning of the cutting process.

1. Adjust the parallel stop to the desired width.

2. With your ﬁngers closed, place your hands ﬂat on the workpiece and push it along the

parallel stop into the saw blade (3).

3. Always push the workpiece up to the end of the riving knife (34) using the push stick

(15).

For lengthwise cuts to very narrow workpieces with a width of 50 mm or less, a push block

must be used (not included in the package contents).

1. Adjust the parallel stop to the desired width.

2. Push the workpiece with the push block against the stop rail and push the workpiece to

the end of the splitting wedge using the push stick.

Always replace cracked push blocks on a timely basis.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ferrex DX254TS Manual

Product: