779800
31
Zoom out
Zoom in
Previous page
1/42
Next page
29
Operation
X. Operation
m WARNING! Risk of injury!
Improper assembly of the table saw can result in serious injury.
-Before start-up, assemble the table saw properly and completely.
-Before switching the table saw on, make sure the saw blade is correctly mounted and that
mobile parts can move freely.
After switching on the saw, you must wait until the saw blade (3) has reached the maximum
speed before you perform the cut.
Switching the table saw on and off (Fig. 1 / Pos. 8)
-To switch on the table saw, lift the cover flap (8) and press the green operating switch I. The
motor will start.
-To switch the table saw off, push the cover flap (8) to switch off.
Changing the speed (Fig. 1)
The table saw has 2 speed ranges:
To operate the saw at a speed of 3200 rpm (non-ferrous metals), set the speed switch (7) to
Slow-position.
To operate the saw at a speed of 5000 rpm (wood), set the speed switch (7) to Fast-position.
Sawing with the table saw
m WARNING! Risk of injury!
Improperly handling the table saw poses a risk of serious injury.
-When performing lengthwise cuts, do not stand directly in front of the table saw, instead
stand diagonal to the cutting line.
-When performing bevel cuts, always use the parallel guide.
-Use a push stick or a push block to safely push the workpiece by the saw blade. Immediately
replace a damaged or worn push stick.
-Secure long workpieces so that they do not tip over at the end of the cut. Use a roller stand
for this, for example.
-After switching on the table saw, wait until the saw blade has reached its maximum speed
before you perform the cut.
-Only operate the table saw with an extraction device.
-Each time after making a new setting, perform a test cut to check the set dimensions.
-Check and clean the suction channels regularly.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DX254TS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info