779800
32
Zoom out
Zoom in
Previous page
1/42
Next page
30
Operation
Performing lengthwise cuts
A lengthwise cut is applied to cut a workpiece lengthwise. Push an edge of the workpiece
against the parallel stop (5) with the flat side on the saw table.
1. Lower the saw blade guard (4) onto the saw
table. The saw blade guard is pushed up by the
workpiece while sawing.
2. Switch on the dust extractor first and then the table saw.
3. With your fingers closed, place your hands flat on the
workpiece and push it along the parallel guide into
the saw blade (3) .
4. Guide the workpiece laterally just to the front edge of
the saw blade guard with your left hand.
5. Always push the workpiece up to the end of the riving knife (34) using the push stick (15).
Performing bevel cuts
1. Set the saw blade to the desired angle.
2. Set the parallel guide corresponding to the width and height of the workpiece.
3. Lower the saw blade guard (4) onto the saw table.
4. Perform the cut corresponding to the width of
the workpiece.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DX254TS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info