779800
36
Zoom out
Zoom in
Previous page
1/42
Next page
Kapitelüberschrift
34
XII. Maintenance
m Warning! Prior to any adjustment, maintenance or service work disconnect the mains
power plug!
General maintenance measures
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as pos-
sible. Wipe the equipment with a clean cloth or blow it down with compressed air at low
pressure.
We recommend that you clean the equipment immediately after you use it.
Clean the equipment regularly with a damp cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the equipment. Ensure
that no water can get into the interior of the equipment.
In order to extend the service life of the tool, oil the rotary parts once monthly. Do not oil the
motor.
Brush inspection
In case of excessive sparking, have the carbon brushes checked only by a qualified elec-
trician. Important! The carbon brushes should not be replaced by anyone but a qualified
electrician.
XIII. Storage
Clean the electrical power tool as described in the section ‘General maintenance measures’.
Store the electrical power tool and its accessories in a dark, dry, frost-free and well ventilated
place out of reach from children. The ideal storage temperature is between 10 and 30°C.
Keep the operating instructions with the power tool.
m NOTE!: Observe these operating instructions to check the power tool for possible for wear
and damage before re-using it.
XIV. Electrical connection
The electrical motor installed is connected and ready for operation. The connection com-
plies with the applicable VDE and DIN provisions. The customer‘s mains connection as
well as the extension cable used must also comply with these regulations.
Important information
In the event of an overloading the motor will switch itself off. After a cool-down period (time
varies) the motor can be switched back on again.
Maintenance/Storage/Electrical connection
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DX254TS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info