779800
38
Zoom out
Zoom in
Previous page
1/42
Next page
Kapitelüberschrift
36
XVI. Troubleshooting
Fault Possible cause Remedy
Saw blade is loose
after the motor is
switched off
Fixing nut not tight enough Tighten fixing nut with right-hand
thread
Motor does not
start
a) Mains fuse blown a) Check mains fuse
b) Extension cable defective b) Replace extension cable
c) Connections to the motor or
switch not OK
c) Commission check by an
electrician
d) Motor or switch defective d) Commission check by an
electrician
Motor turning
sense incorrect
a) Capacitor defective a) Commission check by an
electrician
b) Incorrect connection b) Have an electrician transpose the
wall plug poles
Motor does not
supply power,
protection is
tripped
a) Cross section of the extension
cable insufficient
a) See electrical connection
b) Overload due to blunt saw
blade
b) Replace saw blade
Burn areas at the
cutting surface
a) Blunt saw blade a) Have saw blade sharpened (only
by an authorised sharpening
specialist) or change it
b) Incorrect saw blade b) Replace saw blade
Troubleshooting
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DX254TS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DX254TS in the language / languages: English as an attachment in your email.

The manual is 4.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info