663878
8
Zoom out
Zoom in
Previous page
1/16
Next page
8
Stage 1: (If your knife is already reasonably sharp, skip Stage 1 and go directly to Stage
2.) If you are sharpening a knife for the first time or if the knife is very dull, start in Stage
1. Pull the knife once through the left slot of Stage 1 (Figure 5) by slipping the blade
between the left angle guide and the plastic knife hold down spring and moving the blade
downward in the slot until it engages the diamond coated disk while pulling the blade. You
will hear it make contact with the disk. Insert the blade as close as possible to its bolster
or handle. If the blade is curved, lift the handle slightly as you sharpen near the tip of the
knife, keeping the blade edge approximately parallel to the table. Sharpen the entire blade
length. For an eight (8) inch blade each pull should take about 4 seconds. Pull shorter
blades through in 2-3 seconds and longer blades in 6 seconds. Next, repeat with one full
length pull in the right slot of Stage 1.
Note: Each time you insert the blade you should simultaneously pull the blade toward you.
Never push the blade away from you. Apply just enough downward pressure to make con-
tact with the wheel – added pressure does not improve or speed the sharpening process.
To ensure even sharpening along the entire blade length, insert the blade near its bolster
or handle and pull it at a steady rate until it exits the slot. In each Stage make an equal
number of pulls, alternating in the left and right slots, in order to keep the edge facets
Figure 6. Develop a distinct burr along knife edge
before stropping in Stage 3.
Figure 5. Stage 1. Inserting blade in slot between
guide and knife hold down spring. Alternate left and
right slots.
Figure 8. Inserting blade in left slot of Stage 2.Figure 7. Burr can be detected by sliding fingers
across and away from the edge.
Caution! See text.
Move fingers
across and
away from edge
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EdgeCraft Chef-s Choice - Commercial 2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EdgeCraft Chef-s Choice - Commercial 2100 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info