663878
7
Zoom out
Zoom in
Previous page
1/16
Next page
7
and level, slide it down between the plastic spring and the guide plane and pull it toward
you at a uniform rate as it contacts the sharpening or stropping disk. You will be able to
feel and hear the contact as it is made. Always keep the blade moving uniformly through
each stage; do not stop the pull in mid stroke. Consistent pull speed of about 4 seconds per
stroke for an eight (8) inch blade is recommended. The time can be less for shorter blades
and more for longer blades.
Never operate the sharpener from the back side.
Use just enough downward pressure when sharpening to ensure uniform and consistent
contact of the blade with the abrasive disks on each stroke. Additional pressure is
unnecessary and will not speed the sharpening process. Avoid cutting into the plastic stop
bar of the Sharpening Module (see Figure 3). However, cutting into the stop bar will not
functionally impact operations of the sharpener or damage the edge.
INSTRUCTIONS
Read This Before You Start To Sharpen
The EdgeSelect Sharpening Module is designed to sharpen either Straight edge or Serrated
edge knife blades.
1. Sharpen Serrated Blades Only in Stage 3. Do not sharpen serrated blades in Stages 1 and
2 as that may remove more metal than necessary from the serrations. See Section titled
Procedure for Sharpening Serrated Blades for more details.
2. Straight Edge blades can be sharpened in all three stages, however, use of Stage 1 may be
necessary only if the knife is very dull or if you wish to create an edge with extra “bite”.
See following Section for more details.
Procedure for Sharpening Straight Edge Blades
Straight Edge Blades: Sharpening First Time
Before you turn on the power, slip a knife blade smoothly into the slot between the left
angle guide of Stage 1 and the elastomeric spring. Do not twist the knife (Figure 5.)
Move the blade down in the slot until you feel it contact the diamond disk. Pull it toward
you, lifting the handle slightly as you approach the tip. This will give you a feel for the
spring tension. Remove the knife and press the Power Switch. A red “indicator” on the
switch appears when this switch is turned “ON”.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EdgeCraft Chef-s Choice - Commercial 2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EdgeCraft Chef-s Choice - Commercial 2100 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info