475724
24
Zoom out
Zoom in
Previous page
1/135
Next page
24
+ Measure the oil quantity accurately as a small deviation of it
has a large effect on the ratio of mixture in particular for
small fuel quantities.
+ Do not change the ratio of mixture. This will lead to more
residues of combustion, a higher fuel consumption, a
decrease of output or damages to the engine.
Mix petrol and oil in the supplied fuel mixing can (38).
Â
Fill first petrol up to the mark .
Then, fill oil up to the mark
.
Shake the fuel mixture.
Fuels have only a limited shelf-life. Outdated fuels and fuel
mixtures may result in starting problems. Therefore, mix only
that quantity of fuel which you can use.
Only store fuels in containers approved and identified for
this. Keep fuel containers in a dry and safe area.
Make sure that fuel containers are kept out of the reach for
children.
C Make sure to dispose of fuel remainders and liquids
used for cleaning according to relevant regulations and in an
environmentally compatible manner.
F
F
u
u
e
e
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
c
c
h
h
a
a
i
i
n
n
s
s
a
a
w
w
Stop the engine and allow it to cool down.
Wear protective gloves.
Avoid eye and skin contact.
Strictly follow the instructions under “Safe
handlin
g
with fuels”.
1. Clean the area around the filler neck. Contamination in the
tank may result in malfunction.
2. Â
Carefully open the tank cap (9) to allow possible
overpressure to relax.
3. Shake the container once more before pouring the fuel into
the tank.
4. Carefully fill the fuel mixture up to the lower edge of the filler
neck. Avoid spilling of fuel or oil. Clean the chain saw
immediately when you have spilled fuel or oil.
C Make sure that no fuel can come into the soil.
5. Carefully close the tank cap after fuelling and check that it
does not get loose during operation.
6. Check that there is no leakage on the tank cap and fuel
lines. If there are leaks this product may not be started.
7. Clean the tank cap and the area around it.
Go away at least three metres from the fuelling place to
start the chain saw.
C
C
o
o
m
m
m
m
i
i
s
s
s
s
i
i
o
o
n
n
i
i
n
n
g
g
You may not start to operate the machine until you
have read these original instructions, observed all the
instructions given and installed the machine as described!
+ Check for every use:
- there is no damages at the machine.
- loose fastenings
+ Make sure that the ON/OFF switch, the throttle lock-out
switch, the throttle trigger and the chain brake properly work.
Observe the safety instruction in any case.
C
C
h
h
a
a
i
i
n
n
b
b
r
r
a
a
k
k
e
e
 The chain brake is a protective mechanism that is
triggered when the chain saw strikes backwards or
automatically by the front hand guard (3). The saw chain
stops immediately (< 0,1 sec.).
Checking of chain brake
Check the chain brake’s proper function before each work start.
Start the engine, see “Starting the chain saw”.
Hold the chain saw with both hands and allow the engine to
run.
Â
Use the back of your hand to press against the front
hand guard
.
The chain saw must stop immediately.
It is not allowed to use this chain saw without
properly working chain brake. Please contact the
manufacturer or the customer service point.
Before starting the chain saw
 Apply the chain brake. Push the front hand guard
forward.
Have a safe standing position.
Â
Place the chain saw on the ground in front of you, with
the guide bar and chain showing to the left.
Chain and guide bar must stand free.
Put the right foot tip in the rear handle (29) and hold the
front handle (4) with your left hand.
Starting with cold engine
 Put the toggle switch (8) to its top position.
Pull the choke lever (7) fully out.
L The extent of choke lever pulling depends on the outdoor
temperature.
Colder outdoor temperature: Pull the choke lever fully
out.
Warmer outdoor temperature: Pull the choke lever
halfway out.
Â
Grasp the cranking handle and slowly pull the cranking
rope until a resistance is felt. Then, pull quickly and
firmly. While doing so, press the front handle (4) down.
Do not fully pull out the cranking rope and slowly
guide the cranking handle back to make sure that
the cranking rope is correctly wound up.
When the engine starts immediately press the choke
lever in. The engine will idle.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika BKS 45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika BKS 45 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info