475724
22
Zoom out
Zoom in
Previous page
1/135
Next page
22
 Strong trunks and strong tension
n Place one cut (one third of the diameter of the trunk) from
buttom up.
o Then place a second cut with distance to the first cut from
top which cuts through the trunk.
Advices on how to cut off branches
 Step cut
n Make the first cut from the bottom up (one third of the
branch diameter).
o Then, make the second cut from top to bottom opposite to
the first cut. This cuts the branch through.
p To remove the remaining piece from the trunk cut it
through from top to bottom close to the trunk.
Advices for cutting down trees
Such work may only be carried out by instructed
specialists.
+ Pay attention to the length of the guide bar. Only those trees
are allowed to be cut which have a trunk diameter which is
smaller than the length of the guide bar.
+ Â
Safeguard the dangerous zone (D) before cutting.
Make sure that there are no persons or animals in the
fall area. Danger to life!
+ Â
The minimum distance to the next work place must
be 2.5 tree lengths.
+ Â
Make sure that the working area around the trunk is
free of risk to stumble and that you have an escape route (F)
which is free of obstacles.
 Before cutting the tree down decide on the felling
direction (C). Before chopping the tree decide on the
chopping direction.
Consider in this case the balance point
of the treetop, neighbour trees, slope direction, state of
health of the tree and the wind direction.
On this side the
kerf is cut in.
+ Remove interfering branches, scrub and obstacles from the
working area at the trunk and make sure that you have a
safe standing position.
+ Thoroughly clean the trunk foot – sand, stones and other
foreign objects make the saw chain edgeless or may
damage it.
+ Consider the state of health of the tree – be careful with
trunks with damages or deadwood (droughty, rotten or dead
wood).
Â
Tree felling technique:
B Cut a kerf with the saw of approximately one third of the
tree diameter into the trunk. First of all place the
horizontal cut and then as secondly a cut from top in an
angle of 45°.
B Shout the warning "Caution" or "Tree is falling"
before starting the fell cut.
B Now saw on the opposite side of the trunk a horizontal
chopping cut.
This cut should be placed a bit higher
(appr. 4 cm) than the horizontal cut of the kerf.
B By no means cut through the trunk.
Appr. 1/10 of the
trunk diameter must remain.
If the tree starts falling
ahead of time pull out the chain saw immediately out of
the cut and step back or to the side.
B Push a key into the horizontal chopping cut in order to
make the tree falling.
B Pay attention, when tree starts falling, to perches or
twigs falling down.
A
A
s
s
s
s
e
e
m
m
b
b
l
l
y
y
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
g
g
u
u
i
i
d
d
e
e
b
b
a
a
r
r
a
a
n
n
d
d
t
t
h
h
e
e
s
s
a
a
w
w
c
c
h
h
a
a
i
i
n
n
Risk of injury!
Stop the engine and wear protective
gloves whenever working on the
guide bar and on the saw chain!
 Place the chain saw on a level surface and release the
chain brake. Press the front hand guard (3) against the
front handle (4).
 Remove the cover (13).
Â
Place the guide bar.
Put the saw chain over the clutch (17) on the chain
wheel (18) Â
and insert it in the circumferential
guiding groove of the guide bar.
Attend to the correct running direction of the chain
links!
When assembling, pay attention that the chain
are lying correctly within the guide slot and on the
chain wheel.
Â
Turn the chain stretching screw (15) anticlockwisely
until the chain stretching pin (16) is in its end position.
Â
Remount the cover (13) and tighten the nuts (14) hand-
tight.
The chain stretching pin(16) must engage in the
provided hole in the guide bar.
Clamping the saw chain as described in section
„Clamping the saw chain”
C
C
l
l
a
a
m
m
p
p
i
i
n
n
g
g
o
o
f
f
s
s
a
a
w
w
c
c
h
h
a
a
i
i
n
n
Risk of injury!
Stop the engine and wear protective
gloves whenever working on the
guide bar and on the saw chain!
Â
Loosen the retaining nuts (14) by max. 1 turn.
Â
Slightly lift the guide bar tip and turn the chain stretching
screw (15) clock wisely until the correct chain tension is
reached.
Â
The saw chain is correctly stretched when it can be
lifted in the centre of the chain guide by appr. 3 – 4 mm.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika BKS 45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika BKS 45 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info