702725

Aritech DO505 Manual

13
Zoom out
Zoom in
Previous page
1/44
Next page
-12-
Installing the pillars
Pre-drill holes in the pillars, aligned with the ground plate holes. The maximum height of the pillar must be
taken into consideration (max. length 1.5 m or 3.0 m, depending on the ground plate).
For wall mounting, leave approximately 4 mm at the mounting side for the cover. If the pillars are to be installed
inside a building, a ground plate can be also used instead of a cover, so no minimum distance is required.
A tamper switch can be used to further secure the top and bottom covers. This must be installed and locked at
the upper and/or lower end of the pillar. When installing the covers, the switch must be activated.
Installing the devices in the pillars
The transmitters and receivers are inserted into the pillars at the desired height and fastened by screws. Before
installing the devices, confirm where the cables will pass in the pillars.
The installation is made easier as the devices and pillars have already been assembled, wired and tested in the
laboratory. Consequently, only the underground cable needs to be connected on site.
Installing heating elements
When used outside, the devices and pillars must be equipped with heaters in order to prevent condensation on
the optical devices.
As shown in the illustration,
the heating elements are inserted
into the board (Fig. 1.8, page 1) at the base of the devices.
Pillars should be equipped with at least one panel heating element per 0.5 meter of pillar above ground level.
The panel heating elements are inserted in the pillars and secured at the correct mounting height.
Heaters can use either AC or DC. If running by AC, an ordinary transformer can be used.
Connections (Fig. 1.7)
Receiver Transmitter
1
2
3
4
5
6
7
8
9
10
11
+ / operational voltage
- / operational voltage
tamper (only for single units)
tamper (only for single units)
vacant for terminal resistance
NO
COM
NC
armed / disarmed
disqualification
first alarm memory
1
2
3
4
+ / operational voltage
- / operational voltage
tamper (only for single units)
tamper (only for single units)
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech DO505 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech DO505 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info