Manual Zipper ZI-RPE60 (page 22 of 52) (English, German, French, Spanish)

644523

Zoom out

Zoom in

1/52

Controlling the belt tension.

2.4.2 Working area

The right humidity in the ground is very

important for right tamping. Water is use

as a lubricant to help that the earth parti-

cles are pushed together.

Too less humidity causes not enough

tamping.

Too much humidity causes gaps which

are filled with water.

The machine may not be used on hard,

frozen or mixed earth that contains

scraps of bricks.

Too high watering or excessive water

contents can cause a stalling of the ma-

chine.

2.4.3 Starting

Turn on the ignition (Fig. B) by turning it

onto the position ON.

Set the petrol cock 13 (Fig. C) onto the

position ON (right).

Turn the Choke 12 (Fig. C) onto the posi-

tion OPEN (left).

IM PORT AN T

When the choke stands on the

closed position, the fuel mixture

gets concentrated for starting of

the cold engine. The position

OPEN produces the right fuel mix-

ture for the usual operation after

starting and for starting the ma-

chine when the engine is hot.

Adjust the throttle control 11 (Fig. D) at

half throttle.

Grab the starting handle (Fig. E) and

start moving it slowly. At one position the

resistance gets very hard. Let the cable

rewind a bit and pull on it powerfully.

ATTENTION:

NEVER pull the cable till the end of it.

NEVER skip the cable after pushing on it.

Let it rewind.

Start the engine with the starting handle.

Let the plate compactor running warm for

about 2 minutes at half throttle.

Set the wished engine speed with the

throttle control and start working.

2.4.4 Stopping

Turn back the throttle control to idling

mixture

Turn off the ignition

Close the petrol cock.

Before storing the machine it must get

cold.

2.4.5 Operation instructions

Operate the machine by postponing the

handle sidewise.

Always hold a good stand do that you

can’t slide or lose the control of the ma-

chine.

When the machine has an optional water

tank you can adjust the flowing speed by

using the cock in the tube.

One meter around the machine and into

the working direction there mustn’t be

any person except of the operator.

During tamping and raising of an earth

building you have to tamp about 100 to

150 mm inside the edge two or three

times. Then you can tamp the edge.

When tamping earth in the middle of a

building the plate shouldn’t touch the re-

inforced concrete piles, the underground

construction the ground of the machine

and the underground pipes.

During workings in the inside of a build-

ing the plate and the eccentric block

mustn’t strike the walls.

When lots of machines work together, the

distance between the front machine and

the machine that is behind it should be at

least 10 m. The parallel distance

shouldn’t be less than 5 m.

When the machine works on soft or rough

ground you have to decrease the engine

speed by using the throttle control so

that the machine doesn’t sink. When

there is a descent you have to take care

that the plate compactor doesn’t faint.

You have to take care extremely in the

following dangerous areas:

 At tunnel workings you have to cater

for a good ventilation to avoid acci-

dents. There must be a functioning

control system for the supply of fresh

air.

 Near landlines there’s a high danger

of electrical shocks. Only the opera-

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zipper ZI-RPE60 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 1,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zipper ZI-RPE60 Manual

Product: