517530

ZCS 9L2BL Manual

12
Zoom out
Zoom in
Previous page
1/36
Next page
12
User’s manual
EN
Marking the boundary of the work area
3. Check the entire lawn surface and assess whether it is necessary to
divide it into separate work areas. Before installing the perimeter wire,
check the entire path to make this procedure easier. The illustration
shows an example of a lawn with the track for burying the perimeter
wire.
During installation, identify any secondary areas and closed areas. A
secondary area is a section of lawn connected to the primary lawn
with a passage that is diffi cult for the robot to reach. The area must
be reachable without any rises or drops greater than those allowed.
Whether a zone is to be defi ned a “secondary area” also depends on
the size of the primary area. The larger the primary area, the harder it
will be to reach narrow passages. More generally, a passage narrower
than 200 cm (78.74 ") is considered a secondary area. The number
of secondary areas managed depends on the characteristics of the
model (See “Technical Specifi cations”).
The minimum passage allowed is 70 cm (27.56 ") from each edge of
the perimeter. The perimeter wire must be positioned at a distance of
(to be indicated below) from any objects outside the lawn; therefore,
the total passage should be 140 cm (55.12 ").
If this passage is very long, then it is better for the passage to be wider
than 70 cm (27.56 ").
During programming, it is necessary to confi gure the size of the
secondary areas as a percentage of the lawn, and the quickest
direction for reaching it (clockwise or anti-clockwise), as well as the
number of meters of wire needed to reach the secondary area. See
“Programming Mode.”
24 v
Track for laying the perimeter wire
min. 70 cm / 27,56 "min. 70 cm / 27,56 "
min. 70 cm / 27,56 "
corridor with a minimum passage
of 70 cm / 27,56 " from edge to edge.
PRIMARY AREA
SECONDARY AREA
If the aforesaid minimum requirements are not met and therefore, i.e.
an area separated by a rise or drop with characteristics that cannot be
managed by the robot or a passage (corridor) narrower than 70 cm
(27.56 ") from perimeter edge to perimeter edge, this area of the lawn
area is considered a “Closed Area.” To mark a “Closed Area” lay the
outgoing and incoming perimeter wire in the same track at a maximum
distance of 1 cm (0.40 "). In this case, the robot is unable to reach
the area autonomously and must be managed as described in the
chapter “Management of Closed Areas.” The management of “Closed
Areas” reduces the square meters that can be managed by the robot
autonomously. It is recommended to use the “Management of Closed
Areas” only for areas smaller than 900 m2 (9684 sq.').
corridor with a passage
< 70 cm / 27,56 "
PRIMARY AREA
CLOSED AREA
drain cover
flowerbed
30 cm./ 11,8 "
30 cm./ 11,8 "
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZCS 9L2BL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZCS 9L2BL in the language / languages: English as an attachment in your email.

The manual is 10,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ZCS 9L2BL

ZCS 9L2BL User Manual - Dutch - 56 pages

ZCS 9L2BL User Manual - Dutch - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info