517530
11
Zoom out
Zoom in
Previous page
1/36
Next page
11
User’s manual
EN
SETTING UP THE PERIMETER WIRE
Before installing the perimeter wire, it is necessary to check the entire
surface of the lawn. Make any necessary adjustments to the grassy
surface during the laying of the perimeter wire in order to allow the robot
to operate properly.
1. Proceed with “Preparation and marking the boundaries of the work
areas”.
2. Installation of the perimeter wire.
3. Installation of the charging station and power supply-transmitter unit.
4. When laying the perimeter wire, respect the installation direction
(clockwise) and the rotation direction around the owerbeds
(anticlockwise), as shown in the gure.
24 v
track for laying the perimeter wire
PREPARATION AND MARKING THE BOUNDARIES OF THE WORK AREAS
Preparation of the lawn to mow
1. Make sure the lawn to mow is even and does not contain holes, stones
or other obstacles. Otherwise, prepare the lawn by lling in any holes
and removing any obstacles. If some obstacles cannot be removed,
it is necessary to properly mark these areas with the perimeter wire.
2. Check that no areas of the lawn exceed the allowable slopes (see
“Technical Speci cations.” When operating on slopes, the wheels
may slip when the robot detects the wire causing it to fall outside the
perimeter. To prevent this from happening, the “Slope Kit” and “clawed”
wheels can be installed. If the kit is installed and the ground conditions
are suitable (compact, without excessive depressions and holes,
etc.), the robot can work (within certain limits) outside the maximum
allowable slope limits (see the gure).
Important
Areas with slopes greater than those allowed cannot be
mowed with the robot. Therefore, position the perimeter
wire before the slope so that it is not included in the area
to mow.
NO
21-35%
0-20%
21-35%
0-35%
100 cm (39,3 ")
35 cm (13,78 ")
35 %
perimeter wire
35 cm (13,78 ")
NO
NO
OK
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZCS 9L2BL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZCS 9L2BL in the language / languages: English as an attachment in your email.

The manual is 10,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ZCS 9L2BL

ZCS 9L2BL User Manual - Dutch - 56 pages

ZCS 9L2BL User Manual - Dutch - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info