724636
12
Zoom out
Zoom in
Previous page
1/21
Next page
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
(toll free)
AFTER SALES SUPPORT
(toll free)
Digital Inverter Generator with Pure Sine Wave
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
20 21
Starting your Generator
NOTE: As the oil tank is not shipped with oil before starting the engine,
ensure you have lled the oil tank to the correct level with oil, and make sure
fuel has been added to the fuel tank (26).
1. Before starting, check to ensure the 240Va.c Outlet Power On/O switch
(1 ) is in the right hand side “OFF” position, and ensure that no electrical
appliance is connected to the generator by removing any appliance cords
from the outlets (Fig. K/L).
2. Turn the fuel tap / lever (23) clockwise to the ‘ON position (Fig. M).
When vertical it is in the correct position.
3. Push the choke lever (16) towards the front of the generator to the full
choke “START position (Fig. M). Choke is not necessary if the engine is
already warm and youre restarting. The direction for the choke is also
indicated below the choke lever (16) on the air lter cover (17).
Operation Operation
K. L.
OFF
Engine oil replacement
1. Place the generator on a at and level surface and
warm up the engine for several minutes. Then stop
the engine.
2. Place an oil pan at the front of the generator
ensuring it is in front of the oil ller cap/dipstick
(12) area. Commence removing the oil ller cap/
dipstick (12) by rotating in an anti clockwise
direction to remove, so that the oil can be
completely drained from the oil reservoir.
WARNING: Oil may be warm to hot. It is recommended to wear gloves
for protection.
3. Tilt the generator forwards (Fig I), so that the oil can drain from the oil
reservoir into the oil pan.
4. Reinstall the oil ller cap/dipstick (12) and rotate in a clockwise direction
until secure.
5. Refer to the previous instructions on page 18 for “Filling and checking the
engine oil” to rell the oil reservoir.
CAUTION. Check that no foreign material, debris, dust enters the crankcase.
6. Ensure to replace the oil ller cap/dipstick (12) after relling with fresh oil by
securing it in a clockwise direction.
N.
RUN
FRONT OF GENERATOR
START
M.
ON
OFF
Operation
Before Starting your Generator Economy mode
This inverter generator is tted with an economy
switch (29).
When the economy switch is turned on (Fig J),
the speed of the generator motor is reduced, thus
reducing fuel consumption, noise and ware and tear.
This economy setting is suitable for all low current
draw appliances.
In the event a larger appliance is turned on, the speed of the generator is
automatically increased to maintain a constant output.
Where a large appliance is known to be used, it is always better to turn the
Eco Switch to the OFF position so the sudden increase in power requirement
is not eected with the speed of the motor building up to speed.
J.
ON
I.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone EP2800i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone EP2800i in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info