724636
11
Zoom out
Zoom in
Previous page
1/21
Next page
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
(toll free)
AFTER SALES SUPPORT
(toll free)
Digital Inverter Generator with Pure Sine Wave
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
18 19
1. Before checking or relling oil, be sure the
generator is put on a stable and level surface,
ensuring the engine has been switched OFF.
When lling with oil you can lift the generator
approximately 100 mm at the front (Fig G),
however the generator must be sitting at back on
its feet when checking the level of oil using the oil
ller cap/dipstick (12).
Make sure you check the capacity of fuel tank
before checking the oil level. The fuel tank
(26) should be less than 50% full when the
generator is tilted by 100mm to ll the oil
reservoir, or fully drained if the generator is
tilted more than 100mm.
2. Remove the oil ller cap/dipstick (12)
by rotating the cap in an anti-clockwise
direction, and wipe all oil residue o the oil
ller cap/dipstick (12) with a clean rag.
Re insert the oil ller cap/dipstick (12) and
thread the cap fully in position.
Then remove the oil ller cap/dipstick (12) by rotating in an anti clockwise
direction and view the oil level on the oil ller cap/dipstick (12).
3. If the oil level is close to or below the lower level line, rell using the supplied
oil bottle (32) with 4 stroke oil to the upper level line (Fig H).
Do not use the generator when the oil level is close to the low level. Fill the
oil tank before use each time.
4. If the oil is contaminated or has discoloured, ensure you change the oil.
Replace the oil ller cap/dipstick (12). DO NOT start the generator with the
oil Filler cap/dipstick (12) not rmly replaced.
NOTE: This engine is tted with a low oil indicator light (4). If the oil level
is too low the engine will stop operating or the engine will not start. It is
advised to check the oil level each time the generator is used and ll to the
upper mark on the oil ller cap/dipstick (12) by the above method.
Do NOT over ll.
Preparation Information Preparation Information
WARNING.
Do not rell fuel tank (26) while engine is running or is hot.
Check to ensure that the fuel drain (10) has been tightened and that fuel is
not leaking.
Be careful not to admit dust, dirt, water or other foreign objects into the fuel.
Wipe o spilt fuel thoroughly before starting engine.
Ensure you DO NOT fuel the generator in close proximity to any open
ames, lit cigarettes, or hot objects.
The generator should also be located in an open area with fresh air and NOT
in a conned area.
WARNING: Ensure the engine is switched o while undertaking
this task.
1. Remove the fuel tank cap (27) by rotating in an anticlockwise direction.
2. Remove the fuel tank inlet lter (24) and ensure it is clean and free of debris.
Check the level of fuel is sucient.
3. If the fuel tank inlet lter (24) was removed to check the fuel level, ensure it
is replaced back before adding fuel.
4. To add fuel, pour the unleaded fuel from an approved fuel container into the
fuel tank (26). As fuel expands, DO NOT FILL to the lip of the tank. Maximum
ll is to the top of the fuel tank inlet lter (24) rim.
5. Replace fuel tank cap (27) turning in a clockwise direction to lock.
Filling and checking the Engine oil
The engine of this generator is NOT lled with oil when unpacked.
Prior to starting the engine ensure the oil tank is lled with SAE 10W-30
4 stroke oil. For the rst time ll the engine should be lled with 550ml
(+/-10%) of SAE 10W-30 oil. We recommend GARDENLINE® Full Synthetic
4 Stroke Oil.
NOTE: Damage to the engine is not covered under warranty if the engine is
run with insucient oil.
NOTE: Ensure the fuel tank cap (27) is secure before attempting to add oil.
G.
H.
UPPER
MARK
LOWER
MARK
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone EP2800i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone EP2800i in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info