724617
19
Zoom out
Zoom in
Previous page
1/32
Next page
16V Lithium-ion Cordless Drill
AFTER SALES SUPPORT
(toll free) MODEL No.: CDT214XA • 05/2019 • 1956
e-mail: info.aldi@positecgroup.com
AUS
17
1300 889 028
AUS
CAUTION. Do not continue to overload the drill/driver and constantly reset the
overload. Doing this will cause the battery cells to over heat.
Temperature cut out
If the drill/driver is constantly overloaded, or the drill/driver is used constantly at
maximum rating in high ambient conditions, the battery cells may overheat causing
the battery pack to shut down.
When this occurs you will need to allow the battery cells to cool.
NOTE: The drill/driver will not restart until the battery pack has cooled. To reduce the
temperature of the cells remove the battery pack from the drill/driver and place the
battery pack in a free air environment, out of direct sunlight or any other heat source.
DO NOT force cool the pack in any way. Do not place in refrigerators or freezers.
When the battery pack has cooled down it can again be used to operate the
drill/driver, as long as the load or the conditions causing the original excessive
temperature has been corrected.
Low voltage cut out
The battery pack used on this tool is tted with a low voltage cut out feature within
the circuitry.
The low voltage cut out feature operates when the voltage drops below a preset
value. This feature automatically stops the drill/driver from operating (similar to that
of the overload condition). When this condition occurs you will need to either insert
another battery into the drill/driver or recharge the existing battery.
The low voltage cut out feature has been added to maximise the life of the battery
cells in the battery (8). When this occurs, recharge the battery pack by following the
battery charging section in this manual.
NOTE: Attempting to restart the tool without either recharging the battery or
installing another battery (with charge) will lead to drill/driver restarting and then
stopping again, after only a few seconds of operation.
Ambient temperature ranges
The ambient temperature range for tool, battery use and storage is 0
o
C-45
o
C.
The recommended ambient temperature range for the charging system during
charging is 0
o
C-40
o
C.
Operation
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone CDT214XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone CDT214XA in the language / languages: English as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info