724617
18
Zoom out
Zoom in
Previous page
1/32
Next page
16V Lithium-ion Cordless Drill
AFTER SALES SUPPORT
(toll free)MODEL No.: CDT214XA • 05/2019 • 1956
e-mail: info.aldi@positecgroup.com
AUS
16
1300 889 028
AUS
H.
G.
CAUTION. Extended use of the variable speed under load will overload and then
permanently damage the speed control.
Drill/driver Overload
This drill/driver is tted with an overload protection. If the drill/driver is excessively
forced, or the task being performed is too great for the drill/ driver, the drill/driver will
automatically go into an overload mode. When the drill/driver goes into overload, the
drill/driver will automatically and suddenly STOP. To reset the overload, simply release
the trigger. When the trigger is pressed again, the drill/driver will restart. Resume work
after the overload has been reset, but reduce the load by using a smaller drill/driver
bit or re-sharpen the existing drill/driver bit and reduce the amount of force placed
on the drill/driver. If the drill/driver is set to High speed on the gear selector, consider
changing to low speed selection.
Operation
Using the drill/driver
Trigger switch
1. Use the forward/reverse switch (5) to select the
direction of rotation (Fig G), then pull the trigger (7)
(Fig H). This trigger switch is an electronic variable
speed control which enables the user to vary the
speed continuously.
The speed varies according to how far the trigger
switch is depressed.
The further it is depressed the faster the chuck will
rotate and the lighter it is depressed, the slower it
will rotate.
2. To stop the drill/driver, release the trigger switch (7).
NOTE: The variable speed control tted to this drill/
driver is NOT intended to be used for long periods
of time during the operation of the task being
performed. Use the variable speed to start drill/
driving and screwing tasks, and then fully depress
the trigger once the task has started.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone CDT214XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone CDT214XA in the language / languages: English as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info