807264
8
Zoom out
Zoom in
Previous page
1/8
Next page
page 8page 9
Position the 8 wheel locators appropriate to the cycle sizes to be tted.
Outward position for adult (medium/large) cycles.
Inward facing position for very small cycles.
Slide the wheel holder onto the rail, locate bolt into the channel underneath.
Align the square section of the bolt with the rail cut out.
C
5.
Push the 13 pin plug through the centre hole.
Self
Tapper
x 4
ST P
Route wires into the cable lower channels.
Ensure wires are not trapped !
Mount number plate frame using screws .
ST
Support
Frame
Tube
Support
Frame
Tube
Attach the clamp arms to the carrier support frame.
Place nut within the Thumb nut wheel. Push nut in tight to prevent
the nut falling out on approach to the clamp xture bolt.
Attach the protective rubber to the clamp arms as shown. Ensure the rubber
does not impede the safe operation of the ratchet system.
KL
J
When tting the
actual number
plate do not screw
through the back-
plate where the
lighting cable may
get damaged.
Ensure the Thumb nut and bolt are seated properly, do not over tighten.
6.
7.
RP
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Witter ZX404 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Witter ZX404 in the language / languages: English as an attachment in your email.

The manual is 4.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info