649002
13
Zoom out
Zoom in
Previous page
1/30
Next page
Super Finish 27 • 31
35
GB
Remedy in case of disturbance
9. 
  Measure for elimination of mal-
function
 No voltage.
Fuse protection has reacted. For example
an agitator is connected to the socket
on the unit. This agitator has not been
switched o before switching on the
unit Super Finish 27 or 31.
The unit switches o automatically in
case of overloading. The green control
lamp in the multifunction switch
extinguishes.

independently.
Check voltage supply
First switch on the unit Super nish 27 or
31 and then, for example, the connected
agitator.
The green control light will light up again
after 2 - 3 minutes. Then set multifunction
switch to (OFF).
Switch unit on again (ON –
circulation), then set multifunction switch
to (spray).
 
Filter extends beyond the liquid level
and sucks in air.
Suction lter congested.
Suction pipe not tightened, i.e. the unit
sucks in ancillary air.
Device with upper hopper:
Filter disk congested.

Inlet valve trigger leaks, sucks in
ancillary air.
Super Finish 27:
Inlet valve is clogged, cannot be pressed
down into inlet valve housing.

Inlet valve is clogged
Rell coating material.
Clean or replace suction lter.
Clean and tighten connections.
Clean or replace lter disk.
Replace stripper and O-ring, see page 37,
point 11.1.
Switch o unit -
(OFF)
Inlet valve must allow movement; test by
pressing the inlet valve slightly with a soft
implement (e.g. a pencil). Moving the inlet
valve back and forth removes impurities
from the valve seat. If this does not help,
screw the inlet valve out of the paint section
and clean it, refer to page 37, point 11.2.
Switch o unit - (OFF)
Press inlet valve trigger (g. 17, item 1) several
times; this releases the clogged inlet valve.
1
Attention


-never hit the inlet valve
trigger with a hammer.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wagner Super Finish 31 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wagner Super Finish 31 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 5,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info