785222
19
Zoom out
Zoom in
Previous page
1/40
Next page
Pin Function
5 Allow to discharge
6 Allow to discharge
7 Alarm relay NC
8 Alarm relay COM
9 Alarm relay NO
10 Remote on/off H
11 Remote on/off L
The multi connector’s screw terminal can be pulled out of the Lynx Smart BMS, allowing for easy wiring.
The remote on/off (pin 10 and 11) of the terminal are interconnected with a wire loop. In case the remote on/off connection is
used, remove the loop and wire as desired.
1 2 3 4 5 6 7 8 9 10 11
Multi connector
Multi connector location
6.2.5. Connect the GX device
Connect the Lynx Smart BMS VE.Can port to the GX device VE.Can port using a RJ45 cable.
Multiple VE.Can devices can be interconnected, but make sure that the first and the last VE.Can device both have a VE.Can
RJ45 terminator installed.
Power the GX device from the AUX + and AUX – terminal of the Lynx Smart BMS
VE.Can RJ45
terminator
VE.Can RJ45
terminator
RJ45 UTP
cable
GX device
power cables
Wiring example Lynx Smart BMS and GX device
Lynx Smart BMS
Page 16 Installation
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Lynx Smart BMS 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Lynx Smart BMS 500 in the language / languages: English as an attachment in your email.

The manual is 3.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info