798771
4
Zoom out
Zoom in
Previous page
1/8
Next page
WIRING AND MOUNTING THE DIGITAL CONTROL:
1) Locate the Green Terminal Block on the back of the Digital Control in the upper right
corner. Using a small screwdriver, loosen the two screws to open the clamping jaws
enough to insert the RTD Wire ends.
2) Insert a bare wire end on one of the RTD Wires into the clamping jaws on one post of
the Terminal Block. Tighten the screw to securely attach the wire. Do not over
tighten. Repeat this process on the remaining wire. The RTD Wires may be
connected to the Terminal Block in any combination.
3) Along with the RTD Wires, feed the wiring from the Digital Control into the opening in
the Pellet Hopper.
4) Carefully insert the Digital Control into the opening in the Pellet Hopper. Again, you
may need to adjust the angle of the Digital Control to allow the circuit board to pass
through the opening.
5) Using the two screws that mounted the Smoker Control, attach the Digital Control to
the Pellet Hopper. Do not over tighten the screws.
6) Connect the Molex Connectors according to the color coding shown on the Digital
Control Wiring Diagram. You may have some excess length for the RTD Wires. This
additional wiring can be coiled and secured to the Digital Control Wiring with a cable
tie or a twist tie. Make sure that none of the wires interfere with the fan blades on the
Draft Inducer Fan or the Auger Drive Motor.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger BAC331 - Digital Thermostat Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger BAC331 - Digital Thermostat Kit in the language / languages: English as an attachment in your email.

The manual is 0.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info