798771

Traeger BAC331 - Digital Thermostat Kit Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
INSTALLATION INSTRUCTIONS
REMOVING THE EXISTING SMOKER CONTROL:
1) Make sure the Switch/Dial is in the OFF position. Disconnect the Power Cord from
the electrical outlet.
2) Review the Digital Control Wiring Diagram to familiarize yourself with the color coding
of the wiring connections. Disconnect the wiring from the Smoker Control by
separating the 4 Molex Connectors found on the underside of the Pellet hopper.
3) Remove the two screws securing the Smoker Control to the Pellet Hopper. Save
these screws as they will be used to mount the Digital Control later.
4) Carefully remove the Smoker Control through the opening in the front of the Pellet
Hopper. You may need to adjust the angle of the Smoker Control to allow the circuit
board to pass through the opening. Save the Smoker Control in case you should
have a problem with your Digital Control. It can be reinstalled until the problem with
the Digital Control is resolved.
INSTALLING THE RTD:
1) Open the Door and remove the Porcelain Grill and Grease Drain Pan to provide
access to the left side of the Grill.
2) Carefully cut the cable tie securing the RTD Wires to the RTD. Remove the Screw
and Lock Nut from the RTD mounting bracket if they are attached.
3) Thread the RTD Wires through the center hole of the RTD Grill Filler and then
through the small hole in the left end of the Grill. Continue to feed the RTD wires
through the Grill until the lower end of the RTD can be inserted into RTD Grill Filler.
On new Grills there will be a “Digital Thermostat RTD Mounting Hole” label pointing to
the holes in the RTD Grill Filler. Refer to the RTD Installation Diagram for additional
information.
4) Mount the RTD to the RTD Grill Filler using the 1/2” long Screw and the Lock Nut as
shown in the RTD installation Diagram. Tighten to secure the RTD.
5) Run the RTD Wires down through the space between the end of the Grill and the
Pellet Hopper. Then feed the Wires up through the opening for the Control.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger BAC331 - Digital Thermostat Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger BAC331 - Digital Thermostat Kit in the language / languages: English as an attachment in your email.

The manual is 0.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info