636719
15
Zoom out
Zoom in
Previous page
1/18
Next page
15
Operation
For moving the line forward you tap the trimmer head lightly against the ground while the engine
runs at full speed.
Hold the trimmer at an upright angle towards the area that is to be cut.
Stones and walls, and poles cause the line to be worn down very fast.
Small trees and bushes can be easily damaged by the brush cutter.
See Fig. 8 for working direction for trimmer head and with blade.
Start / Stop.
How to start a cold engine
1. Place the brush cutter on a flat stabile surface.
2. Set the switch to ( I ). See Fig.. 6A
3. Press 8-10 times on the fuel pump under the air filter, see Fig. 6B.
4. Set the choke lever to start position, see Fig.7A
5. Pull the start cord out slowly from engine until resistance is felt. Then pull strongly in start cord.
Always feed the start cord back into the engine by hand. Repeat up to 3 times until initial ignition is
heard.
6. Set the choke lever to drive position, see Fig. 7B
7. Pull the start cord (according to point 5) until the engine runs.
How to start a warm engine
1. Set the choke lever to drive position, see Fig. 7B
2. Pull the start cord until the engine runs.
How to stop the engine
1. Release the throttle button.
2. Set the switch to ( O ) position, see Fig. 6A
Vibrations may travel up into the handle
during use. We therefore recommend taking
a break every 2 hours.
Fuel
This product is equipped with a two-stroke engine that demands two-stroke oil added to the petrol.
Always use unleaded gasoline.
Never use ready-mixed gasoline/oil from service stations that is normally used for mopeds,
motorbikes, etc.
Use a clean and approved petrol can for mixing the petrol with oil.
Use an approved two-stroke oil for air cooled engines, chainsaws, trimmers etc. (Do not use oil for
out board engines of boats. (Mix only small quantities).
Mixing instructions:
We recommend the Texas Motex 2tx in a 2.5% mixture. That means mixing 0.1 l of 2-stroke oil with
4 l of unleaded gasoline.
Always follow the guidelines of mixture given by oil manufacturer.
When storing the machine for more than 30 days you should empty the tank.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas BCU33M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas BCU33M in the language / languages: English, Danish as an attachment in your email.

The manual is 1,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info