608664
163
Zoom out
Zoom in
Previous page
1/588
Next page
Warm start.
1. Engage the transmission (14:A1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (11:A)
4. Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7.7.1.
Models 4WD:
Cold start
1. Engage the transmission (15:A1; 15:B1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (12:A)
4. Pull the choke out completely (12:B1).
5. Turn the key in the ignition and start the en-
gine.
Before starting work with the machine,
wait a few minutes for the oil to warm
up.
Warm start.
1. Engage the transmission (15:A1-B1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (12:A)
4. The choke must be pressed in (12:B2).
5. Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7.7.1.
7.7.1 Operation
To operate with the machine proceed as described
below:
Press the pedal (10:B) right down then release
it.
Activate the pedal (10:F) to move the machine.
Go to the work area.
If front accessories have been installed, activate
the PTO (11:D, 12:D).
Commence work.
7.8 STOPPING
To stop the machine, proceed as follows:
Disengage the PTO (11:D; 12:D).
Engage the parking brake (10:B)
Allow the engine to idle 1-2 mins.
Turn o the engine by turning the ignition key.
Close the fuel cock. This is particularly
important if the machine is to be transported on
a trailer for example.
If you have to leave the machine unat-
tended, disconnect the spark plugs and
remove the key from the ignition.
The engine may be very warm immedia-

     

7.9 CLEANING
-
ne, silencer, battery and fuel tank free
from grass, leaves and oil
      
check the machine for oil and/or fuel
leaks.
    
This can damage shaft seals, electrical
components or hydraulic valves.
Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
Do not spray water directly onto the engine.
Clean the engine with a brush and/or
compressed air.
Clean the motor cooling air intake.
After cleaning using water, start the machine
and any cutting means assembly to remove
any water which may otherwise end up in the
bearings and cause damage.
8 USING THE ATTACHMENT
Make sure the grass to be cut is com-
 
stones etc.
8.1 CUTTING HEIGHT
For best results, cut o the top third of the grass.
See g. 23.
If the grass is long and needs cutting back signi-
cantly, cut twice using two dierent cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting means being
damaged against the surface and the lawn’s top
layer of soil being removed.
8.2 MOWING TIPS
To get the best mowing results, follow the tips
given below.
EN
ENGLISH
(Translation of the Original Instructions)
17
163


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga 740 WX - P 901 CH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga 740 WX - P 901 CH in the language / languages: All languages as an attachment in your email.

The manual is 110,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info