Manual Stiga 740 WX - P 901 CH (page 164 of 588) (All languages)

608664

164

Zoom out

Zoom in

1/588

• Cut grass frequently.

• Run the machine at full revs.

• Grass should not be wet.

• Only use sharp cutting means.

• Keep the bottom side of the cutting means

clean.

9 MAINTENANCE

9.1 ASSISTANCE PROGRAMME

To keep the machine in good working order in

terms of reliability, safety and environmental

protection, always adhere to the GGP servicing

programme.

The points of intervention for this programme

are illustrated in the attached GGP maintenance

manual.

The Basic Service must always be carried out by

an authorized service workshop.

The First Service and Intermediate Service should

be carried out by an authorized service workshop,

but can also be carried out by the user.

The procedures are indicated in the handbook and

are described in the chapter “7 START-UP AND

OPERATION” as well as here below.

The checks carried out by an authorized service

workshop guarantee professional workmanship

and the use of genuine spare parts.

The handbook is stamped every time a Basic Ser-

vice is performed and each time an Intermediate

Service is carried out by an authorized service

workshop. A handbook with these stamps increa-

ses the second-hand value of the machine.

9.2 PREPARATION

All service and all maintenance checks

must be carried out on a stationary ma-



Always apply the parking brake to stop

the machine from moving.

Stop the engine.

Prevent inadvertent start-up of the en-

gine by disconnecting the spark plug

cables and removing the ignition key.

9.3 MAINTENANCE TABLE

See chapter "13 MAINTENANCE SUM-

MARY TABLE". The table is designed to



and safe working order. It indicates the

main operations to be performed and

the frequency of the same. Perform the

relative operation described based on



Change the oil more frequently if the

      -

tions or when the ambient temperature

is high.

9.4 TYRE PRESSURE

Adjust the tyre pressure to meet the values provi-

ded in “0 TECHNICAL DATA TABLE”.

9.5 ENGINE OIL TOP-UP/CHANGE

For this maintenance operation, see

also the manual for the engine supplied

with the machine.

9.5.1 Inspection / top-up (21; 22)

 

To check the level, make sure the ma-

chine is on even ground.

Wipe around the dipstick. Unscrew it and

pull it out. Wipe the dipstick clean.

Push the dipstick down completely wi-

thout screwing it into place.

Now unscrew and pull the dipstick up



Top up if the level is lower than the

“FULL” mark (21; 22).

       

“FULL” mark. This results in the engine



“FULL” mark, the oil must be drained

until the correct level is achieved.

Change the oil more frequently if the engine has

to work in dicult conditions or when the ambient

temperature is high.

9.5.2 

For the frequency of this intervention

see chapter 13.

ENGLISH

(Translation of the Original Instructions)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga 740 WX - P 901 CH in the language / languages: All languages as an attachment in your email.

The manual is 110,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stiga 740 WX - P 901 CH Manual

Product: